Writing ladder program
I want to read the PLC program saved in the computer and write it to the PLC.
Please tell me how to operate the programming software ?
Connect port 1 (programmer port) to your computer.
Start the programming software, read it from the personal computer, and write it to the PLC.
For details, please see the video below.
D0 / D2 / SU / SJ / PZ series software used: kpp
This video is an introduction using D2-265 as an example. Please read the model selection as per your own product.
D0 / D2 / SU / SJ / PZ series software used: DirectSOFT5
This video is an introduction using D0-06 as an example. Please read the model selection as per your own product.
There are no plans to upgrade DirectSOFT 5 in the future.
Take this opportunity to consider migrating to kpp (Koyo plc Programming Software).
You can download kpp for free
SA / SR series software used: DirectSoft5
If the project is not registered in DS Launch
At that time, set the serial port to be COM1 to COM8.
Click here for inquiries by email